第一部分 多孔介質傳熱傳質
1.不平衡熱力學在熱、質輸運中的套用2.毛細多孔介質中發生高強度熱質交換時的微分方程組
3.聚氨酯泡沫塑膠的導熱係數和熱老化機理
4.多孔介質傳熱傳質研究的進展與展望
5.Investigation on moisture transfer mechanism in porous media during rapid drying process
6.Determination of permeability using fractal method for porous media
7.利用分形方法確定聚氨酯泡沫塑膠的有效導熱係數
8.多孔介質導熱的分形模型
9.多孔介質微波冷凍乾燥的升華-冷凝理論
10.離心力場作用下多孔介質中強制對流換熱的研究
11.Experimental investigation on heat,moisture and salt transfer in soil
12.Study of heat and moisture migration properties in porous building materials
13.Modeling of heat and mass transfer in unsaturated wet porous media with consideration of capillary hysteresis
14.測量含濕多孔介質局部含濕量的針型電容法
15.太陽輻照條件下土壤內溫濕度場的動態模擬
16.太陽輻照、大氣對流下未飽和土壤中熱質遷移過程的實時仿真研究
17.分形多孔介質的粒子擴散特點(Ⅰ)
18.被乾燥多孔物料中孔隙大小及分布的探討
19.顆粒表面料層乾燥機理
20.含內熱源可燃多孔介質熱量傳遞及影響因素分析
21.多孔介質熱導率的數值計算
22.Experimental study on shrinkage and rehydration of seed during drying process
23.Investigation on drying characteristic of medical pill using microwave-convective drying
24.有限存貯空間內可燃多孔介質流動和傳熱的研究
25.Role of surface roughness characterized by fractal geometry on laminar flow in microchannels
第二部分 沸騰與相變換熱
1.液體泡狀沸騰放熱的研究2.Behavior of a liquid droplet impinging on a solid surface
3.運動液滴的LEIDENFROST現象
4.過熱液體中汽化成核過程的研究
5.低溫液體泡狀沸騰換熱的準則方程
6.衝擊液滴的泡狀沸騰換熱
7.單個液滴碰擊表面時的流體動力學特性
8.多孔物料床中沸騰強化的極限熱流密度和臨界熱流密度
9.池內泡狀沸騰的管束效應
10.Analysis on hysteresis in nucleate pool boiling heat transfer
11.Dynamic behavior and heat transfer of a liquid droplet impinging on a solid surface
12.Study on boiling heat transfer in liquid saturated particle bed and fluidized bed
13.Study on pool boiling heat transfer of llano-particle suspensions on plate surface
14.Investigation on steam condensation front propagation in porous media
15.A molecular dynamics simulation of bubble nucleation in liquid and with heated surface
16.泡狀沸騰時的壁面熱物性效應
17.固體顆粒強化液體沸騰換熱和抗垢特性的研究
18.固體顆粒對池沸騰換熱表面上結垢影響的機理分析
19.納米顆粒懸浮液池內泡狀沸騰的實驗研究
20.凍乾過程熱質耦合效應的數值計算
21.Hydrodynamics and heat transfer characteristics of fluidized particles in nucleate pool boiling
22.加熱方式對真空冷凍乾燥過程的影響
23.The effects of sublimation-condensation region on heat and mass transfer during microwave freeze drying
24.Close-contact melting in a spherical enclosure
25.固體PCM在熱球體外表面上接觸融解時液膜厚度變化規律的研究
26.微波冷凍乾燥過程中光纖測溫技術的研究
27.泡沫金屬內流體凍結相變的傳熱過程
28.生物組織凍結相變過程的數值模擬
29.Study on flow and heat transfer characteristics of heat pipe with axial“Ω”-shaped microgrooves
30.套用Duhamel定理確定固體界面上的瞬時熱流密度
31.微通道冷凝研究的進展與展望
32.相變微膠囊功能流體融化狀態的數值模擬
33.Three-dimensional numerical simulation for annular condensation in rectangular microchannels
第三部分 流化床傳熱傳質
1.水平埋管在流化床稀相中的傳熱研究2.Heat transfer to horizontal tube and tube bundle in freeboard region of gas fluidized bed
3.流化床稀相中水平管束的傳熱特性
4.Investigation on the incipient fluidization and heat transfer in a centrifugal fluidized bed dryer
5.Experimental investigation of the heat and mass transfer in a centrifugal fluidized bed dryer
6.Numerical simulation of particle trajectory in the free board region of a centrifugal fluidized bed
7.離心流化床中氣固傳熱特性的實驗研究
8.Determination of marginally stable zone of gas-solid magnetically fluidized beds
9.用波動理論確定氣固磁流化床的臨界穩定區
10.離心流化床中強制對流換熱的實驗研究
第四部分 工程傳熱問題
1.Numerical simulation of the performance of a capillary thermal driven ejector refrigerator2.Study on water transport in PEM of a direct methanol fuel cell
3.毛細驅動蒸汽噴射式製冷系統的研究
4.熱管噴射式空調系統中噴射器的研究
5.Numerical simulation of the temperature proffles Of the normal and malignant female breast
6.Numerical simulation of the performance of an absorption heat transformer
7.太陽能液體除濕空調系統再生和蓄能特性的研究
8.直接甲醇燃料電池質子交換膜內兩相逆流的研究
9.Numerical simulation of the performanee of a solar-earth SOLIrce heat pump system
10.Numerical study on dehumidifying process in falling film dehumiditier
11.帶有透明蜂窩太陽房的模擬計算
12.恆熱流豎壁層流降膜換熱特性研究
13.下降液膜層流換熱發展段中的積分分析
14.節能型生態住宅冬季供暖系統性能的數值模擬
15.太陽能驅動第二類吸收式熱泵的模擬研究
16.太陽能液體除濕空調系統中除濕器形式的選擇
17.秸稈類生物質熱解特性及其動力學研究
18.蓄能型溶液除濕蒸發冷卻空調系統中除濕器研究
19.直接甲醇燃料電池雙極板冷卻通道的熱設計
20.對流邊界條件下豎板降膜除濕過程中傳熱傳質的數值模擬
21.1.x級LiBr吸收式製冷循環性能分析
22.泡沫鋁翅片傳熱和流動特性的實驗研究
23.直接甲醇燃料電池陽極流道兩相流動的擬沸騰模型(I)流動壓力降的計算
24.新型分形樹狀冷卻通道流動特性的研究
25.微流動細胞顆粒中介電泳力的分析
26.雙效氨水吸收式製冷循環的性能
27.基於線熱源理論的垂直U型埋管換熱器傳熱模型的研究
28.單室火災煙氣運動的雙層區域模擬
29.房間空調系統動態特性的分析
